SparkFun Electronics SparkFun Zubehör

SparkFun Zubehör The MCP3002 has a 10-bit analog to digital converter (ADC) with a simple to use SPI interface. Use this IC if your microcontroller does not have an ADC or have enough ADC lines. A great chip when you need to add additional ADC lines.Features:2.7V to

SparkFun Zubehör This is a simple knob that connects to the extra large sized linear slide potentiometer. Each knob uses friction to secure itself to fit onto the slide pot. Once attached this small knob provides you with an easier to use potentiometer for your proj

SparkFun Zubehör The new generation 18 pin PICAXE microcontroller now has parallel tasking touch sensors and more memory/RAM.See the Info Sheet for a comparison of features between the 18M2 and the 18M2+PICAXE is a neat entry-level microcontroller system that is rel

SparkFun Zubehör Heating Pad - 5x10cm

SparkFun Zubehör You don't have to worry about adding a resistor to an LED if you get an LED with a built in resistor! This pack of 25 yellow 5mm LEDs will help alleviate any frustrations you've had with accidentally burning them out by having a resistor in the diode

SparkFun Zubehör Screw Terminals 5mm Pitch (3-Pin)

SparkFun Zubehör This is the SMD version of PRT-07948 which is the unit we like to use as RTC backup and SRAM backup for GPS units. Holds battery in place with friction. The metal housing connects to the positive side of the battery and the PCB pad underneath is con

SparkFun Zubehör This is a 10-pack of wires that are pre-terminated with an alligator clip on one end and a hookup pigtail on the other. Alligator clips are a staple item for any workbench or makerspace and with these cables you will be able to easily incorporate th

SparkFun Zubehör This is a black plastic bezel custom made to mate with the silicon rubber pads. Black 1/8" ABS plastic. Using two of these bezels with two of the top bezels will create a 4x4 bezel appropriate for the full button pad.Documents:DimensionalMulti-Unit

SparkFun Zubehör LEDs - those blinky things. A must have for power indication pin status opto-electronic sensors and fun blinky displays.This is a very standard green LED. The lens is 3mm in diameter and is diffused.Features:2.0-2.4 VDC forward dropMax current: 2

SparkFun Zubehör Potentiometers are incredibly useful whether you're controlling the volume on your stereo or the 'mood lighting' in your room. The problem with traditional potentiometers is the fact that your microcontroller doesn't have an easy way to interface wi

SparkFun Zubehör This right-angle tactile switch has a great 'click' to it. Also because it's a through-hole design it's very sturdy. Mount it on the edge of your board for easy access. These are rated for 12VDC at 50mA.